Smart Sights

Get Mark

Calculate mark. Set distance units to meters, yards or feet.

The distance can be specified from the peg, or the eye. If the ground to target is flat distance to peg is all thats needed. If the ground is sloped an angle (measured from eye) can be input as well. Angle can be measured with range finder or inclinometer and entered, or measured by pressing Measure then hold to eye and sight along phone to target.

Setup Marks

Enter marks for calibration.

Smart Sights uses an algorithm to fit your data to its physics model. The calculation takes about a minute on a typical phone, but you will end up with marks closely matched to your shooting at all distances. At least 2 marks are needed but using more will provide a closer fit. The calc field shows the model fit. Discrepancies between the best fit model and actual shooting are inevitable, but Smart Sights will apply a correction so you will get marks aligned to how you have entered them, and with interpolated error correction in between set marks.

Marks can be entered in meters or yards, measured from peg or eye. Angle is optional.

Card

Printable card for IFAA Field and Hunter courses. Can be cut out together or separately and folded. These can be used as a back up or if you prefer to estimate angles and interpolate without a calculator.

Sight Tape

Printable sight tape in yards or meters.